Perle Systems Switch DS1 Uživatelský manuál stáhnout pdf (Strana 215)

Setting Jumpers 215

Introduction

Digital I/O Module

IOLANs that have Digital I/O have an input/output jumper that must be set for each channel and must

match the software configuration for each channel. Depending on the model, the placement of the

digital I/O board can change, so the diagram below shows how to set jumper for any digital board.To

change the settings, do the following:

1. Detach the IOLAN from the electrical power source and disconnect everything from the box.

2. Open the case by unscrewing the five side screws, two on each side plus the grounding screw,

and lifting off the top of the case. You should see the following configuration for the digital I/O

board:

Pin1

Channel 1/3

Channel 2/4

I/O

Note:

Jumper pins 1 and 2 for Input. Jumper pins 2 and 3 for Output.

3. To configure either Channel 1 or Channel 3 (depending on how many Digital channels your I/O

supports and following the mylar channel definitions) for Input, jumper J3 pin 1 and 2 (as

shown); this is the default setting. To configure either Channel 2 or Channel 4 (depending on

how many Digital channels your I/O supports and following the mylar channel definitions) for

Output, jumper J5 pin 2 and 3 (as shown).

4. Close the IOLAN case by replacing the case lid and the five screws. You can now power it on

with the new settings.

1 2 ... 210 211 212 213 214 215 216 217 218 219 220 ... 245 246

Žádné komentáře

Perle Systems Switch DS1 Uživatelský manuál Strana 215