Perle Systems Sds4 Uživatelský manuál stáhnout pdf (Strana 371)

100

101

370

Configuring HTTP Tunnels

Configure the serial port on IOLAN 2, as follows;

When IOLAN 1 boots, it will establish an HTTP tunnel to IOLAN 2.

IOLAN 2 will initiate a connection between the serial device and the IP host. The connection will use

the destination TCP port 20001.

The setup for HTTP Tunnel Host-to-Serial is now complete.

Host-to Host

The following example will demonstrate how to setup an IP Host (10.10.100.2) to an IP Host

(100.10.50.60) connection via an HTTP tunnel. In this example, the hosts are doing a TFTP transfer

which uses the UDP protocol.

Because IOLAN 1 is behind the firewall, it will need to initiate the tunnel connection to IOLAN 2.

For more HTTP tunneling configuration parameters see HTTP Tunneling

Match TCP port num-

ber IP host is listening

on.

Use TCP Sockets

Select the IP host

from host table.

Select “connect to”

Configure connection

to use “tunnel1”.

1 2 ... 366 367 368 369 370 371 372 373 374 375 376 ... 459 460

Komentáře k této Příručce

Žádné komentáře

Perle Systems Sds4 Uživatelský manuál Strana 371

Komentáře k této Příručce

Související produkty a manuály pro Sítě Perle Systems Sds4